SKT-EPT 530/ 550/ 570 DC

Configuration, measurement and quotation

Controller/source conflict: the Chinese body names KS-TM-EPTC; the separate KL-EPTC controller table lists EPT530 and EPT570 but omits EPT550. Omission is not proof of incompatibility, and the body label is not approval for a particular controller or suffix. Confirm the exact EPT submodel, controller nameplate, approved cable and current manufacturer document before selection or installation.

Do not infer EPT530/550/570 ranges or speeds from CG30/50/70, EPT310/330, LEPT or 7-series pages. Numeric accuracy, voltage, bit geometry, start mode and accessory inclusion must be confirmed for the exact delivered set. The suction-tip table names SKT-CG and does not prove EPT compatibility. No exact matching headquarters manual/accessory page has been verified for this grouped listing.

Use the quotation selector to request the exact EPT530, EPT550 or EPT570 configuration. Supply target torque/unit, screw/joint, process speed, tool/controller nameplate photos, both cable ends, bit/fixture and reaction support, I/O and record requirements. Confirm connectors, pinout, ratings and PLC/MES scope before wiring; counting is not measured torque or calibrated angle evidence.

Which configuration can be quoted?

Choose the exact model and provide torque/unit, joint, speed, controller/cable, bits/fixtures, mounting/reaction, I/O/record needs, quantity, delivery location and required date. Sales confirms price, stock and included items.

Is counting the same as a torque record?

No. Confirm measured fields, calibration, units, identification and acceptance separately.