SKT-EPT 310/330 DC

Configuration, measurement and quotation

The tool table specifies KL-EPTC without a suffix. Do not substitute KL-TCG, KL-TCG-L or KL-EPTC-L on the basis of similar names. Confirm the exact tool/controller nameplates, firmware, approved cable, bit/holder drawing and delivered items. DC40V is the tool input, not permission to connect it directly to AC.

The EPT310 lbf·in lower value is published as 0.86 while N·m starts at 0.1; this discrepancy is retained and requires source confirmation. No numeric tool accuracy or repeatability is stated in the public table. Do not copy SNT-CS accuracy or an angle range. The suction-tip table explicitly names SKT-CG; it does not establish EPT compatibility. No exact headquarters accessory/manual match has been verified for this grouped listing.

Confirm I/O connector, pinout, voltage, polarity, isolation and approved wiring. KL-EPTC lists RS-232, Micro SD and LAN, but protocol, software licence, torque/turns/angle export fields and PLC/MES acceptance require separate confirmation. Confirm mounting, clearance, reaction support, calibration, OK/NG, workpiece identity and record retention.

Which configuration can be quoted?

Choose the exact model and provide torque/unit, joint, speed, controller/cable, bits/fixtures, mounting/reaction, I/O/record needs, quantity, delivery location and required date. Sales confirms price, stock and included items.

Is counting the same as a torque record?

No. Confirm measured fields, calibration, units, identification and acceptance separately.